Orma Dispenser of Disposable Shoe Covers

Orma dispenser for dispensable overshoes. Special bracket for support not included.

The surgical protocols require the adoption of the PPE (personal protective equipment) for the operators ant the patients.
Among the required devices to comply with this protocol there is the safety overshoe  (socks) that isolate the shoes, which can have infectious materials.
In normal activities, the patientscan undergo invasive surgeries or therapies without the need ot taking off their clothes, thus they also have to take protection measures, such as the overshoes.

Operating this dispenser is easy , but it make take a little more physical effort to some people.

Benefits:

• ORMA does not need socks to  insert in the device since it uses shrink wrap.
• You will not need to buy socks, so you will save time.
• You will not need to have great quantities of waste.
• You will not need to have socks from different sizes.
• Thus, you will get to save costs.

ORMA automatically “builds” the sock by placing a shoe in the compartiment of the equipments where there is a thermoplastic film. Then, the heating system activates and generates  the sock in real time, adapting to the shape and adjustment of the shoe
The adjustment is so perfect and complete that wrapts and isolates the shoe completely and creates a protective barrier.
The shoe cover is also waterproof and does not creates an obstruction or obstacle for the movement.
The plastic shoe cover lasts longer than the covers made of similar fabric.

Good hygiene image. Adopting the use of the overshoes in your everyday life is synonim of great attention to hygiene and prevention for the staff and the patients.
All of this creates a positive perception in the patients and decreases the distribution of microbes in the surgical environments and operating rooms.
Orma facilitates the management of this procedure, the risk is lessen, the taxes are reduced and the image is improved.
Orma is a fancy and technological device controlled by a card with microprocessor, with programmable controls.

All the cycle of creation and adhesion of the film is made by only inserting the foot on the machine’s step.
A special support has been created (optional) ref. 048-2910S, as assistance to maintain the balance during the phases of preparation and removal of the socks.

Technical features:

• Tension: 230 +- 10 % VAC
• Emission frequency: 50-60 Hz
• Maximum electrical power absorbed: 1300 W
• Power in stand-by: 75 W
• Weight: 22 Kg
• Sizes (width × height × diameter) 445 × 330 × 800 mm
• Level from the floor: 20 mm
• Time for the supply of the film: 4 sec.
• Time for the creation of the shoe cover: 2 sec.
• Time for initial pre-heating: 3 min.

 Optional accesories:

• Ref. 048-2910S   Special support to maintain the balance in the Orma device
• Ref. 048-OR002QFT   Plastic wrap for Orma device