Veterinary vital signs monitor with CO2 capnography

Veterinary Vital Signs Monitor with ETCO2.

The vital signs monitor is intended for use in special procedures in laboratories or in a veterinary clinic where veterinary surveillance systems are needed.

Features:

Heart / pulse rate: It measures with the parameters ECG, oximetry and noninvasive blood pressure (NIBP).

Electrocardiogram (ECG):

• The monitor provides the continuous process of 5 lead ECG, with standard derivation selection and filtering electrocautery discharge.
• You can display up to 3 channels of waveform simultaneously.

Oximetry: The oximetry parameter provides continuous noninvasive monitoring of oxygen saturation (% SpO2) in the arterial and pulse frequency (PR).

Noninvasive arterial pressure (NIBP):

• The noninvasive arterial pressure parameter (NIBP) provides values as systolic and diastolic blood pressure and average plus heart rate.
• NIBP measurements can be made automatically, manually or STAT. 

Respiraty Rate (RR): The monitor provides respiratory rate and Resp wave form by measuring thoracic impedance between two ECG electrodes on the patient's chest.

Temperature (TEMP): Includes two independent temperature control channels (T1 and T2).

CO2:

• The monitor determins the concentration of CO2 in respiratory gases by measuring the amount of light absorbed by these gases.
• EtCO2  is displayed as a numeric value in millimeters of mercury (mmHg), percentage (%) or kilopascals (kPa).
• Furthermore, a CO2 waveform (capnography) can be viewed, a valuable clinical tool which may be used to assess the integrity of the patient´s airway and proper placement of the endotracheal tube.
• The respiratory frequency is calculated by measuring the time interval between the detected breaths.

Monitor:

• The monitor has a colour LCD screen with high resolution and high contrast.
• It provides a continuous, real-time image with up to 4 wave forms. 
• It also shows the measured values, historical data, measurement trends, alarm limits and patient information. 

Internal battery:

• The internal rechargeable battery is primarily intended for backup and switching use.

• The expected life of the battery is 2-5 years, depending on its use.

• A fully charged battery will last 2 to 3.5 hours depending on the usage of the monitor.

You can select patient type:

• Horse
• Dog
• Cat

Technical specifications:

Display:

• 7 inches high resolution, active matrix flat screen (TFT: Thin Film Transistor).

• Resolution: 800 x 480 pixels.

Indicators:

• LED working status
• LED AC power
• LED battery charger
• LED battery supply
• LED alarm silence

Alarm volume: 45dBA to 85 dBA, at 1 metre distance (adjustable).

ECG:

• Heart rate range: 20-350 lpm

• Accuracy of heart rate: 2 lpm or ± 2% (whichever is greater)

• QRS detection range: 0,5 to 5 mV

• Pacemaker pulse detection: Amplitude: 2 mV to 700 mV
• Detection length: 0,1 - 2,0
• Alarm heart rate ranges:
  • High: 20-350 lpm and off
  • Low: 20-350 lpm and off
• Average heart rate: 8 seconds fixed as average
• Lead selection: I, II, III, V, aVR, aVL, or aVF (5-lead)
• Gain display settings: X 1/4, X1/2, X1, X2, X4
• Input range: -5,0 mV to +5,0 mV
• Frequency response: 0,05 Hz to 40 Hz
• Input impedance: Differential > 5 Mohms, as required and tested by ANSI/AAMI EC-13.
• Leakage: < 10 uA
• Isolation of patients: > 4000 VCA
• Waveform display: 120 Hz; 6.25, 12.5, 25, or 50 mm/s
• Frequency digits update: 1 Hz

SpO2:

• SpO2 range: 0-100% functional saturation
• SpO2 accuracy:
  • 70-100% ± 2%
  • <70% unspecified
• Pulse frequency range: 20-350 lpm
• Pulse frequency accuracy: ± 2 lpm or ± 2% (whichever is greater)
• SpO2 alarm range:
  • High: 50 - -100% and off
  • Low: 50 - -100% and off
• Calibration: Factory calibrated SpO2 range of 50% to 100% using human blood samples to a functional saturation. 

NIBP:

• Blood pressure measurement
• Measurement method: Oscillometric with reducing deflation
• Range: Systolic: 40 a 270 mmHg
• Blood average: 30 to 220 mmHg
• Diastolic: 20 to 200 mmHg
• Pulse: 25 to 300 lpm
• NIBP accuracy: Algorithm based on human algorithm that meets or exceeds the accuracy requirements of standards ANSI / AAMI SP10:1992 and 2002 for non-invasive blood pressure using the oscillometric method.
• Inflation pressure setting.
• Measurement time: 30 to 50 seconds (typical), 120 seconds maximum
• Inflation pressure preset:
  • 200 mmHg - Cat
  • 150 mmHg - Dog
  • 120 mmHg - Horse
• Calibration: Factory calibrated
• AUTO time interval: 2, 3, 5, 10, or 30 minutes, or 1, 2 hours 20-260 (in steps of 1 mmHg), and off
• Alarm range: 25- 250 lpm, ± 2% or ± 3 lpm (whichever is greater)
• Pulse frequency accuracy: 251-300 lpm, ± 5%

Respiratory rate (RESP):

• Range: 0-120 breaths per minute (rpm)
• Accuracy: ±1 rpm
• Resolution: 1 rpm
• RESP alarm range:
  • High: 0-120 rpm (1 rpm steps) and off
  • Low: 0-120 rpm (1 rpm steps) and off

Temperature (TEMP):

• Channel: Two
• Range: 25-45ºC
• Accuracy: ± 0.2ºC plus tolerance of the temperature sensor
• Resolution: 0.1ºC
• TEMP alarm range:
  • High: 35.5-43.5ºC and deactivated in 0.1 increments 
  • Low: 35.5-43.5ºC and deactivated in 0.1 increments

CO2:

• Sampling mode: Secondary
• Measurements parameters: Respiratory rate, EtCO2 and InsCO2.
• CO2 warm up time: 10 seconds.
• Measuring range:
  • CO2: 0~150mmHg
  • Respiratory rate: 2~150bpm
• Accuracy:
  • 0~40mmHg ±2mmHg
  • 41~150mmHg ±10% reading
• Resolution: 0.1mmHg
• Flow rate: 50 ml/min±10 ml/min

Power requirements: AC input: 100 to 240 V, 50/60 Hz

Dimensions:

• Width: 300 mm.
• Length: 180 mm.
• Height: 130 mm.
• Weight equipment: 2 kg approx.
• Weight total: 3.6 kg approx.

Environmental protection:

• Temperature:
  • From 0 to 50 0C (operation)
  • From -40 to 75 0C (storage)
• Humidity:
  • From 15 to 95% (operation)
  • From 10 to 95% (storage)

Equipment classification:

• Protection type (againt electrocutions): CLASS I (internal power supply)

• Operation mode: Continuous

• Degree of protection (against liquid ingress): IPX1, drip proof 
• Degree of mobility: Portable 

• Degree of protection (against electrocutions): Type CF

• Safety requirements: EN60601-1:2002 

Includes:

• Veterinarian vital signs monitor 

• Extension cord SpO2 + 2 oximetry sensors

• Cable, ECG, 5-lead + 5 clamps 
• NIBP tube with:
  • NIBP cuff, large, 7-13 cm (horses)
  • NIBP cuff, medium, 6-11 cm (dogs)
  • NIBP cuff, small, 4-8 cm (cats)
• Rectal temperature probe
• Accessories for CO2
• Internal battery
• Power cable
• User manual 

Certification:

• Directive CE 93/42 on Medical Products.